GE Profile PVF18H Instructivo Y Advertencias página 72

Plug in the 3 wire connectors. Route wires into the plastic
6.2
part as shown in the picture.
Place the connectors inside the top housing control.
Insert the water line fully inside the top case hole. Route the
6.3
remaining water line within the plastic part as shown in the
picture.
Remount left hinge cover on top the refrigerator using
6.4
a Phillips screwdriver. Start with the release of cover latch
to assemble it and continue to position the screw and
tighten it in place.
Installation Instructions
REPLACING RIGHT DOOR
7
7.1 Follow these same instructions in reverse from the point 1.4
to 1.2.
REPLACING RIGHT DOOR
8
8.1
door by turning the case leveling screw on the same side,
until the doors are even.
If the unit rocks, re-adjust the leveling screw to the extent
that the unit is stable.
8.2
REPLACING FREEZER DRAWER.
9
Refer to the replacing the Freezer Drawer section for
72
If the doors remain uneven, turn the adjustable pin to raise
the lowest door Using a ¼" hex-key wrench to turn the pin.
instructions.
adjustable pin