Descargar Imprimir esta página

cecotec CONGA FLASH CONNECTED ULTIMATE Manual De Instrucciones página 43

Robot aspirador

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 31
-
The robot will clean the whole surface, edges, around objects such as tables, chairs etc.,
until the battery is low, then it will return to the charging base.
Scrubbing mode. Fig. 20
-
Attach the mop to the mixed tank and fill the tank with water.
-
Place the mixed tank on the robot vacuum cleaner and select the scrubbing level on the
app: high, medium or low.
-
Once you have selected the desired scrubbing level, the robot vacuum cleaner will start the
All in One function to vacuum, scrub and sweep simultaneously thanks to its mixed tank.
Note:
-
If you wish to mop, do not fill the water tank.
-
If the robot has the mixed tank installed with water in it, when it leaves the charging base,
it will turn around itself to soak the mop.
-
To ensure a perfect scrubbing from the start, it is suggested to dampen the mop evenly
with water before fixing it to the mixed tank. It is also recommended to wash the mop
after every use.
-
It is recommended to be present when the robot is scrubbing.
-
When the robot vacuum cleaner returns to the charging base, you must remove the mop.
Do not leave the robot vacuum cleaner charging with the mop assembled.
Spiral mode. Fig. 21
-
The robot will carry out an intense cleaning of a specific area when this mode is activated.
The robot will start cleaning in a specific spot and will move outwards performing spiral
movements (1 metre). Then, it will return to the start point by performing inwards spiral
movements again.
-
Once it has finished and returns to the starting spot, the robot will start cleaning in Auto
mode until it runs out of battery.
-
Before using this mode, place it in the spot you wish to clean.
-
Select the spiral cleaning mode on the app.
Edge mode. Fig. 22
-
When this mode is selected, the robot will clean along walls and around furniture (e.g.
table or chair legs).
-
Select the edge cleaning mode on the app.
Room mode. Fig.
23
-
The robot will carry out a 30-minute cleaning cycle when this mode is selected.
-
Select the room cleaning mode on the app.
-
To ensure an efficient cleaning of the room, make sure the robot stays in the room.
ENGLISH
43

Publicidad

loading

Este manual también es adecuado para:

05795