cecotec HYDROBOOST 2000 Manual De Instrucciones página 12

- Do not spray electrical appliances or cables.
- Do not remove the high pressure hose from the machine
while the system is being pressurised. To depressurise the
device, turn it off, stop the water supply and then press the
trigger 2 or 3 times.
- Do not activate the trigger locking system while the machine
is in operation.
- Do not operate the appliance unless all parts are properly
connected to the main body (handle, gun, nozzle, etc.).
- Make sure to turn on the water supply before turning on
the pressure washer. Running the pump without water can
cause serious damage to the pump.
- Do not use the pressure washer if any parts are missing or
damaged. Check the condition of the product regularly and
repair or replace damaged or worn parts immediately.
- Use only original spare parts supplied or recommended by
Cecotec to ensure safe operation.
- Use only the nozzle included with the product.
- Do not leave the high pressure hose unattended while the
device is operating.
- Hold the high pressure hose and gun firmly when switching
on and while using the machine.
- Do not leave the unit running with the trigger released for
more than one minute, this could damage the pump.
- This device is not designed to pump hot water. Do not
connect to a hot water supply as this will significantly reduce
the shelf life of the pump.
12 HYDROBOOST 2000
- This symbol means that this device is not
suitable to be connected to drinking water
sources.
- Make sure the water inlet pressure is