Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Product performance
Note
The motor of this pressure washer does not run continuously. It only runs when pressing the
trigger. Once the initial procedures in this manual have been carried out, turn the pressure
washer on and press the trigger to activate the pressure washer.
Nozzle cleaning
-
A clogged or partially clogged nozzle can significantly reduce water output and cause
intermittent jetting. To clean the nozzle:
-
Turn off and unplug the unit.
-
Disconnect the water supply. Press the trigger 2 or 3 times to release the pressure
trapped in the hose.
-
Disassemble the wand.
-
Turn the nozzle to concentrate mode, this will activate the internal blades.
-
Use the cleaning clip provided, or any pointed item to clean the nozzle, e.g. insert an
unfolded paper clip into the nozzle hole. Move it inwards and outwards until all dust and
dirt is removed. Fig. 7
-
Pour water through the nozzle hole into the nozzle in order to clean the dirt remains. To
do this, point a lighted garden hose at the nozzle for 30-60 seconds.
High pressure hose angle to surface to be cleaned
-
When spraying water against a surface, the jet achieves maximum impact when sprayed
head-on. However, this type of impact tends to embed dirt particles into the surface,
creating the opposite cleaning effect to the desired. Therefore, the optimum angle for
spraying water against a surface is 45°. Spraying water at this angle improves the impact
and allows it to be combined with more efficient dirt removal. Fig. 8
Distance from the surface to be cleaned
Another factor that determines the impact force of the water is the distance to the surface
to be cleaned. Impact and force of the water increases as the spray nozzle approaches the
surface.
How to avoid damaging surfaces
-
A surface is damaged when the impact of the force of the water is greater than the
hardness of the surface. The impact force will vary according to the settings mentioned
above. Never use a direct jet on surfaces susceptible to damage. Avoid spraying windows
with the direct jet, as they may break.
The best way to avoid damaging surfaces is to follow these steps
-
Before pressing the trigger, move the spray nozzle to the fan spray position.
66
HYDROBOOST 2000
Publicidad
