cecotec HYDROBOOST 2000 Manual De Instrucciones página 69

6. TROUBLESHOOTING
Problem
Smoke comes out
of the appliance.
There is not enough
pressure.
The pressure
washer does not
turn on.
Pressure fluctuates. The pump is sucking in air.
The motor stops
suddenly.
Cause
Overheating, overloading or
motor failure.
The inlet water filter is
clogged.
Air is entering from the hose
connections to the pump.
The nozzle or discharge valve
is worn or not the correct
size.
The unit is pressurised.
The plug is not properly
connected or the socket is
defective.
The extension cord is too long
or short.
The supply voltage is too low.
The thermal safety switch
has tripped.
The nozzle is clogged.
The valves are dirty or worn.
Hydraulic seals are worn.
The extension cord is too long
or short.
The thermal safety
switch has tripped due to
overheating.
Solution
Switch off the device immediately
and contact
the Technical Support
Service of Cecotec.
Clean the inlet water filter.
Check that the connections and the
locking ring are tight.
Contact the official Technical
Support Service of Cecotec.
Press the trigger.
Check the plug,
the socket and fuses.
Remove the extension cord.
Make sure that the mains voltage
matches the voltage stated on the
rating label of the appliance.
Switch off the device and allow it to
cool down.
Check that hoses and connections
are tight.
Clean them with the cleaning clip.
Contact the official Technical
Support Service of Cecotec.
Remove the extension cord.
Make sure that the mains voltage
matches the voltage stated on the
rating label of the appliance.
HYDROBOOST 2000
ENGLISH
69