Publicidad
Idiomas disponibles
Idiomas disponibles
•
This device is not designed to pump hot water. Do not
connect the appliance to a hot-water supply, as this will
significantly reduce the shelf life of the pump.
•
Make sure the water inlet pressure is between 0.01 MPa and
0.4 MPa and that the inlet hose is at least 5 metres long.
•
If the device is to be connected to a drinking-water supply,
install a disconnector on the water pipe to prevent dirty
water from backing up and entering the drinking-water
system. The disconnector must comply with EN 60335-2-
79 ANNEX A.
•
This device must not be controlled by external switching
elements such as timers or connected to electrical circuits
that are continuously switched on and off.
•
Release the trigger when switching from high to low
pressure.
•
Keep the high-pressure hose away from sharp objects.
The burst of a high-pressure hose could cause injury.
Inspect the high-pressure hose regularly and replace it if
necessary. Do not try to fix a damaged high-pressure hose.
•
Keep all connections dry and off the ground to avoid risk of
electric shock. Do not touch the plug with wet hands.
•
Do not use a pressure higher than the one permitted by
the parts of the pressurisation system (high-pressure
hose, connections, etc.). Make sure every component and
accessory is rated to withstand the maximum operating
pressure of the unit.
Repairing double-insulated devices
•
A double-insulated device is equipped with two insulation
systems instead of an earth connection. No earth-
connection means are provided for double-insulated
devices, nor should they be added to the product. The
14
HYDROBOOST 2400 ADVANCECLEAN
Publicidad
