Stihl MS 460 Manual De Instrucciones página 28

2. Cut only one log at a time.
3. Shattered wood should be cut very
carefully. Sharp slivers of wood may
be caught and flung in the direction
of the operator of the saw.
4. When cutting small logs, place log
onto "V" - shaped supports on top of
a sawhorse. Never permit another
person to hold the log. Never hold
the log with your leg or foot.
Rescue Saw
5. Logs under strain: Risk of pinching!
Always start relieving cut (1) at
compression side (A).Then make
bucking cut (2) at tension side (B).
If the saw pinches, stop the engine
and remove it from the log.
6. Only properly trained professionals
should work in an area where the
logs, limbs and roots are tangled.
Working in blow down areas is
extremely hazardous.
7. Drag the logs into a clear area
before cutting. Pull out exposed and
cleared logs first.
English / USA
MAINTENANCE, REPAIR AND
STORING
Maintenance, replacement, or repair
of the emission control devices and
systems may be performed by any
nonroad engine repair establishment
or individual. However if you make a
warranty claim for such a component
which has not been serviced or
maintained properly or if
nonapproved replacement parts were
used, STIHL may deny warranty
coverage.
Never operate a chainsaw that is
damaged, improperly adjusted or not
completely or securely assembled.
Follow the maintenance and repair
instructions in the appropriate section of
your Owner's Manual, especially those
in the chapters "Mounting the Bar and
Chain," "Maintaining and Sharpening"
and "Chain Brake."
!
Warning!
Use only STIHL replacement parts for
maintenance and repair. Use of parts
manufactured by others may cause
serious or fatal injury.
!
Warning!
Always stop the engine and ensure that
the chain is stopped before making any
adjustments, maintenance or repair
work,
27