After Finishing Work; Oil Quantity Control; Taking Care Of Guide Bar - Stihl MS 460 Manual De Instrucciones

Ocultar thumbs Ver también para MS 460:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English / USA
After long period of full-throttle
operation
Allow engine to run for a short while at
idle speed so that engine heat can be
dissipated by flow of cooling air. This
protects engine-mounted components
(ignition, carburetor) from thermal
overload.

After finishing work

:
Slacken off the chain if you have
retensioned it at operating
temperature during cutting work.
The chain contracts as it cools
down. If it is not slackened off, it
could damage the crankshaft and
bearings.
Storing your saw for a short period:
Wait for engine to cool down. To avoid
condensation, fill the fuel tank and keep
the machine in a dry place, well away
from sources of ignition, until you need it
again.
Storing for a long period:
See "Storing the Unit"!
44
Oil Quantity
Control
1
Different quantities of oil are required for
different bar lengths, types of wood and
cutting techniques.
:
Use the adjusting screw (1) (on
underside of machine) to vary the
oil feed rate as required.
:
E = Ematic position, medium oil flow
rate - turn adjusting screw to "E"
(Ematic position)
:
To increase oil feed – turn adjusting
screw clockwise.
:
To reduce oil feed – turn adjusting
screw counter-clockwise.
:
When using as Rescue Saw
turn adjusting screw clockwise as
far as stop. This setting provides
maximum oil feed
Your chain must always be wetted
with a film of lubricant.

Taking Care of Guide Bar

2
1
:
Turn the bar over –
every time you sharpen the chain
and every time you replace the
chain – this helps avoid one-sided
wear, especially at the nose and
underside of the bar.
:
Regularly clean
the oil inlet hole (1),
the oilway (2) and
the bar groove (3).
:
Measure groove depth –
with scale on filing gauge* – in area
used most for cutting.
*
see "Guide to Using this Manual"
3
3
Rescue Saw

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido