Stihl MS 460 Manual De Instrucciones página 61

English / USA
: File the top of the depth gauge
parallel to the stamped service
marking (see arrow) – but do not
lower the highest point of the depth
gauge in this process.
The kickback tendency of the
chainsaw is increased if the depth
gauges are too low.
Sharpening Tools (special accessories)
Chain pitch Round file Ø
inch (mm) mm (inch)
1
/ (6.35) 4.0
4
3
/ PMN (9.32) 4.0
8
3
/ P (9.32) 4.0
8
0.325 (8.25) 4.8
3
/ (9.32) 5.2
8
0.404 (10.26) 5.5
1) Use triangular file 0811 421 8971 for PM1 and RM2
2) consisting of file holder with round file, flat file and filing gauge
60
: Place filing gauge on the chain –
highest point of depth gauge must
be level with the filing gauge.
PM1, RM2:
The rear hump of the tie strap (with
service marking) is lowered along with
the depth gauge.
Round file
Part No.
5
( / ) 5605 772 4006
32
5
( / ) 5605 772 4006
32
5
( / ) 5605 772 4006
32
3
( / ) 5605 772 4806
16
13
( / ) 5605 772 5206
64
7
( / ) 5605 772 5506
32
File holder Filing gauge
Part No. Part No.
5605 750 4327 1110 893 4000
5605 750 4327 0000 893 4000
5605 750 4327 1110 893 4000
5605 750 4328 1110 893 4000
5605 750 4329 1110 893 4000
5605 750 4330 1106 893 4000
RSC3, RMC3, PMC3:
The top of the humped drive link (with
service marking) is lowered along with
the cutter's depth gauge.
The other parts of the triple-humped
tie strap and humped drive link must
not be filed since this may increase
the kickback tendency of the
chainsaw.
: After sharpening, clean the chain
thoroughly, remove filings or
grinding dust – lubricate the chain
thoroughly.
: Before long out-of-service period,
clean the chain and store it in a
well-oiled condition
.
1)
Flat file Sharpening kit
Part No. Part No.
0814 252 3356 5605 007 1027
0814 252 3356 5605 007 1026
0814 252 3356 5605 007 1027
0814 252 3356 5605 007 1028
0814 252 3356 5605 007 1029
0814 252 3356 5605 007 1030
2)
Rescue Saw