Mounting The Bar And Chain - Stihl MS 460 Manual De Instrucciones

Adjusting Depth of Cut
The depth of cut can be set from a few
fractions of an inch up to 7.8 in (20 cm).
Before adjusting the depth of cut:
: Shut off the engine.
: Engage the chain brake by pushing
the hand guard (1) toward the bar
nose - the saw chain should be
locked.
: Place the saw on the ground and put
your right foot in the rear handle and
press down.
Rescue Saw
: Hold the top of the sliding sleeve
with your right hand.
: Loosen the star knob (2) with your
left hand.
: Adjust the depth of cut (arrow).
: Tighten the star knob (2) firmly.
: Disengage the chain brake.
English / USA

Mounting the Bar and Chain

1
a
t = a : 2
You can run chains of different pitches
on this chainsaw – depending on the
chain sprocket (see "Specifications"):
The chain pitch (1) must match the pitch
of the sprocket and the guide bar (for
Rollomatic). The drive link gauge (2)
must match the bar groove width (3).
The pitch is marked on the chain
sprocket and guide bar in inches
(e.g. 3/8 or .325). The groove width
is marked on the guide bar in
millimeters (e.g. 1.6).
If non-matching components of the
wrong pitch or drive link gauge are
run together on the same machine
they may be damaged beyond
repair after a short period of
operation.
2
3
31