Publicidad
Idiomas disponibles
Idiomas disponibles
S S e e t t u u p p
To unpack your product, see the unpacking instructions that are attached to the product inside of the shipping crate.
W W A A R R N N I I N N G G
• Always allow the product to reach room temperature before you set up the product or test functional operations.
Permanent product damage may occur.
• Always operate the product when all operators are clear of the mechanisms.
1. Apply the brake. Push on the product to make sure that all four casters are locked.
2. Release the brake. Push on the product to make sure that all four casters are unlocked.
3. Raise and lower the litter with the hydraulic lift system.
4. Raise the product to the highest height position and put the product in the Trendelenburg position. See Positioning the
product in Trendelenburg (page 11).
N N o o t t e e - - Make sure that the head end lowers to the full lowest height position.
5. Raise the product to the highest height position and put the product in the reverse Trendelenburg position. See
Positioning the product in reverse Trendelenburg (page 11).
N N o o t t e e - - Make sure that the foot end lowers to the lowest height position.
6. Apply the fifth wheel option and make sure that it guides and pivots the product.
7. Make sure that the access doors option open, close, and lock.
8. Make sure that the siderails and endrails raise, lower, and lock in each position: 9 in. (22.86cm), 14 in. (35.56cm), and
26 in. (66.04cm).
9. Raise and lower the manual Fowler backrest (head end section).
10. Raise and lower the manual foot section.
11. Verify proper operation before you put the product into service.
EN
8
1900-009-005 Rev AB.0
Publicidad
