Stryker CUB FL19H Manual De Uso página 15

L L o o w w e e r r i i n n g g t t h h e e l l i i t t t t e e r r
W W A A R R N N I I N N G G
• Always position the patient in the center of the product.
• Always put the product in the lowest position with the siderails up and latched and access doors closed and locked when
you leave a patient unattended on the product. Do not leave the product at a higher height.
• Always remove any devices that may be in the way before you raise or lower the litter.
To lower the entire litter, press down on the center of the uni-lower pedal (B) ( Base controls (page 9)).
To lower the head end of the litter, press down on the side of the uni-lower pedal (C) closest to the head end of the product
( Base controls (page 9)).
To lower the foot end of the litter, press down on the side of the uni-lower pedal (D) closest to the foot end of the product
( Base controls (page 9)).
P P o o s s i i t t i i o o n n i i n n g g t t h h e e p p r r o o d d u u c c t t i i n n T T r r e e n n d d e e l l e e n n b b u u r r g g
W W A A R R N N I I N N G G
• Always make sure the siderails are up and latched before you put the product in a Trendelenburg position.
• Always remove any devices that may be in the way before you raise or lower the litter.
To position the product in the Trendelenburg position (head down), raise the litter to the highest height. See Raising the
litter (page 10).
N N o o t t e e - - Raise the litter to the highest height for a greater Trendelenburg angle.
To lower the head end of the product, push down on the side of the uni-lower pedal (C) closest to the head end ( Base
controls (page 9)).
To lower the product from the Trendelenburg position, push down on the center of the uni-lower pedal (B) until the litter is
flat ( Base controls (page 9)).
P P o o s s i i t t i i o o n n i i n n g g t t h h e e p p r r o o d d u u c c t t i i n n r r e e v v e e r r s s e e T T r r e e n n d d e e l l e e n n b b u u r r g g
W W A A R R N N I I N N G G
• Always make sure the siderails are up and latched before you put the product in a Trendelenburg position.
• Always remove any devices that may be in the way before you raise or lower the litter.
To position the product in the reverse Trendelenburg position (foot down), raise the litter to the highest height. See Raising
the litter (page 10).
N N o o t t e e - - Raise the litter to the highest height for a greater Trendelenburg angle.
To lower the foot end of the product, push down on the side of the uni-lower pedal (D) closest to the foot end ( Base controls
(page 9)).
To lower the product from the reverse Trendelenburg position, push down on the center of the uni-lower pedal (B) until the
litter is flat ( Base controls (page 9)).
1900-009-005 Rev AB.0 11 EN