Descargar Imprimir esta página

Electrolux LSV48400L Manual De Instrucciones página 22

Publicidad

Idiomas disponibles

Idiomas disponibles

22
www.electrolux.com
Problem and alarm code
You cannot activate the
appliance.
The programme does not
start.
The appliance does not fill
with water.
• The lights related to
MY TIME selection bar
flash 1 time intermittent‐
ly.
• An acoustic signal
sounds intermittently.
The appliance does not
drain the water.
• The lights related to
MY TIME selection bar
flash 2 times intermit‐
tently.
• An acoustic signal
sounds intermittently.
The anti-flood device is on.
• The lights related to
MY TIME selection bar
flash 3 times intermit‐
tently.
• An acoustic signal
sounds intermittently.
Malfunction of the water
level detection sensor.
• The lights related to
MY TIME selection bar
flash 4 times intermit‐
tently.
• An acoustic signal
sounds intermittently.
Possible cause and solution
• Make sure that the mains plug is connected to the
mains socket.
• Make sure that there is no damaged fuse in the fuse
box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for
the end of the countdown.
• The appliance recharges the resin inside the water
softener. The duration of the procedure is approxi‐
mately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is
not too low. For this information, contact your local
water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clog‐
ged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the interior filter system is not clog‐
ged.
• Make sure that the drain hose has no kinks or bends.
• Close the water tap.
• Make sure that the appliance is correctly installed.
• Make sure the baskets are loaded as instructed in
the user manual.
• Make sure that the filters are clean.
• Switch the appliance off and on.

Publicidad

loading