HOLZMANN MASCHINEN HBS 700 Manual De Instrucciones página 38

14 OPERATION
14.1 Operation instructions
14.2 Operation
14.2.1 Switch
Turn the power on or off using the Power switch.
Turn the machine on using the green button on the switch box.
Turn off the machine of using the emergency stop. It must be
unlocked before turn the machine on.
There are two indicator lights.
Red light: Power on
14.2.2 Rip fence
Set the rip fence to the desired width (ensure that the largest
section of the material is against the fence).
For precise cutting push in the fine adjustment knob (Y) and tur to
desired position. Then push dokwn the rip fence lock handle.
HOLZMANN MASCHINEN GmbH
Perform all machine settings with the machine being
disconnected from the power supply!
TAKE ATTENTION when cutting long workpieces without
additional support!
Hazard of machine damage and injuries through upbouncing
workpiece.
Therefore: always support long overhanging workpieces additionally
 Let the engine run full speed when you begin to cut a work a
workpiece
 Before the initial start check all screw connections and tighten
them if necessary after
 Check that the saw blade is inserted correctly. In case of
incorrect direction of the band install the saw band new.
Green light: Machine runs
www.holzmann-maschinen.at
HOLZBANDSÄGE / MWOOD BAND SAW / SIERRA DE CINTA / SCIE À RUBAN
W A R N I N G
A T T E N T I O N
N O T I C E
OPERATION
Seite 38
HBS 700 – HBS 800