HOLZMANN MASCHINEN HBS 700 Manual De Instrucciones página 40

15 MAINTENANCE
The machine does not require extensive maintenance. If malfunctions and defects occur, let it be
serviced by trained persons only.
Before first operation as well as later on every 100 operation hours you should lubricate all con-
necting parts (if required, remove beforehand with a brush all swarfs and dust).
Check regularly the condition of the security stickers. Replace them if required.
Check regularly the condition of the saw band and the saw band guide.
The good condition and perfect adjustment of the guiding rollers is essential for a smooth band
guidance and a clean cut.
Store the machine in a closed, dry location.
Clean your machine regularly after every usage – it prolongs the machines lifespan and is a
pre-requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!
15.1 Maintenance plan
15.1.1 After each workshift:
• Relaxing the saw band.
• Disconnect the machine from the power supply.
• Clean the machine entirely.
 Lubricate the blade guide with light machine oil a bit.
15.2 Cleaning
After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal
surfaces as well as the use of scrubbing agents will damage the machine
surface!
Clean the machine surface with a wet cloth soaked in a mild solution
HOLZMANN MASCHINEN GmbH
Don't clean or do maintenance on the machine while it is still connected
to the power supply:
Damages to machine and injuries might occur due to unintended
switching on of the machine!
Therefore: Switch the machine off and disconnect it from the power
supply be-fore any maintenance works or cleaning is carried out
www.holzmann-maschinen.at
HOLZBANDSÄGE / MWOOD BAND SAW / SIERRA DE CINTA / SCIE À RUBAN
A T T E N T I O N
N O T I C E
N O T I C E
MAINTENANCE
Seite 40
HBS 700 – HBS 800