Publicidad
Idiomas disponibles
Idiomas disponibles
15.3
Band saw blade
Wear gloves when handling with saw blades!
Before changing the blade, check that the machine is switched
off and disconnect from the power supply
ATTENTION: Take care to install the saw band correctly!
Check the direction of the teething
15.3.1 Tension band saw blade
Set the blade tension with the blade tension hand wheel (N).
Too much tension: The band saw blade can break
Too less tension: The band saw blade can slip and stop
15.3.2 Change band saw blade
Remove the rip fence rail
Open both doors (upper and lower door)
Turn the blade tension adjustment hand wheel (N) to
release the tension.
Turn the blade tension quick release lever (A1) to fully
realese the tension of blade.
remove the blade and replace the new blade.
15.3.3 Tension V-belt
Rotate the belt tension hand wheel (V) tok adjust the V-belt tension.
HOLZMANN MASCHINEN GmbH
W A R N I N G
HIGHEST RISK OF CUTTING INJURY!
Check the blade tension before any operation
www.holzmann-maschinen.at
HOLZBANDSÄGE / MWOOD BAND SAW / SIERRA DE CINTA / SCIE À RUBAN
W A R N I N G
N O T I C E
MAINTENANCE
Seite 41
HBS 700 – HBS 800
Publicidad
