HOLZMANN MASCHINEN HBS 700 Manual De Instrucciones página 39

14.2.3 Miter gauge
The miter gauge can be used in either groove in the table. Set the
desired angle on the miter scale and make the cut securely holding
workpiece on the miter gauge.
14.2.4 Table tilt
To use the table to perform a bevel cut, loosen the table trunnion
locking lever (M) and turn the table tilt handle.
if the desired tilt is reached re-secure the locking lever.
14.2.5 Push stick
The push stick protects against contact with the band saw blade
 The push stick must be used if the distance
between band saw blade and a rip fence is less
than 150mm
 When the push stick is not used, it have to be
stored nearly the band saw.
 Replace push stick if damaged
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
HOLZBANDSÄGE / MWOOD BAND SAW / SIERRA DE CINTA / SCIE À RUBAN
W A R N U N G
OPERATION
Seite 39
HBS 700 – HBS 800