Publicidad
Idiomas disponibles
Idiomas disponibles
Table of contents
1
Table of contents................................................
2
Introduction ........................................................
3
Product description (Fig. 1) ................................
4
Scope of delivery (Fig. 1) ...................................
5
Proper use..........................................................
6
Safety instructions..............................................
7
Technical data....................................................
8
Unpacking ..........................................................
9
Before commissioning........................................
10 Operation ...........................................................
11 Cleaning and maintenance ................................
12 Storage...............................................................
13 Repair & ordering spare parts ............................
14 Disposal and recycling .......................................
15 Troubleshooting .................................................
16 Warranty conditions - Scheppach 20V IXES
series..................................................................
17 EU Declaration of Conformity.............................
18 Exploded view .................................................... 293
Explanation of the symbols on the
product
Symbols are used in this manual to draw your attention to
potential hazards. The safety symbols and the accompa-
nying explanations must be fully understood. The warn-
ings themselves will not rectify a hazard and cannot re-
place proper accident prevention measures.
Attention! Failure to observe the safety signs
and warning information affixed to the prod-
uct and failure to observe the safety and op-
erating manual can result in serious injury or
even death.
Before commissioning, read and observe
the operating manual and safety instruc-
tions!
Wear safety goggles.
Wear hearing protection.
If dust builds up, wear respiratory protection!
Wear protective gloves!
Attention! Danger of injury! Do not reach into
saw blade while it is running!
19
19
19
20
20
20
25
1
Introduction
25
Manufacturer:
26
Scheppach GmbH
27
Günzburger Straße 69
28
D-89335 Ichenhausen
28
Dear Customer
28
We hope your new product brings you much enjoyment
28
and success.
29
Note:
In accordance with the applicable product liability laws,
30
the manufacturer of this product assumes no liability for
31
damage to the product or caused by the product arising
from:
• Improper handling
• Non-compliance with the operating manual
• Repairs carried out by third parties, unauthorised spe-
cialists
• Installing and replacing non-original spare parts
• Improper use
Note:
The operating manual is part of this product.
It includes important instructions for the safe, proper and
economic operation of the product, for avoiding danger,
for minimising repair costs and downtimes and for in-
creasing the reliability and extending the service life of the
product. In addition to the safety instructions in this oper-
ating manual, you must also observe the regulations ap-
plicable to the operation of the product in your country.
Familiarise yourself with all operating and safety instruc-
tions before using the product. Only operate the product
as described and for the specified areas of application.
Keep the operating manual in a good place and hand
over all documents when passing the product on to third
parties.
2
Product description (Fig. 1)
1.
Handle
2.
On/off switch
3.
Switch lock
4.
Additional handle
5.
On/off switch (laser)
6.
Battery compartment cover
7.
Laser
8.
LED work lamp
9.
Cutting angle scale
10.
Front wing screw
11.
Wing screw (parallel stop)
12.
Parallel stop mount
13.
Saw blade
14.
Flange
www.scheppach.com
Lithium-ion battery
Attention! Laser beam (Fig. 1)
The product complies with the applicable
European directives.
GB | 19
Publicidad
