GYS GYSFLASH 8.48 PL-E Manual De Uso página 8

User manual
▪ Clip the connectors into their sockets on the board.
▪ Pass the cables through the rubber grommets 2 and secure them in the metal plate.
▪ Fix the clamps 3 in such a way that the wired sections inside the casing are not
under tension (M3x20 - TORX 10 screws).
CALIBRATION CABLE FUNCTION
This procedure is used to calibrate the charging cables on the unit, so that the charger can compensate for the voltage
drop caused by the cables as effectively as possible. It is strongly recommended that this procedure is carried out
when the charger is first installed and whenever the cables are modified or changed.
1. Enter one of the lead charging modes.
2. Short-circuit the 2 clamps of the cable (do not short-circuit a battery).
3. Unplug the product from the mains and wait until the charger switches off.
4. Press and hold the
- on: the calibration was carried out successfully.
- on: If the calibration fails, remove the mains plug and repeat the process.
5. Unplug from the mains until the charger switches off.
CHARGE MODES
To modify the charging mode settings, you must:
1. Unlock the charger by pressing the
2. Select the mode by pressing the
3. Lock the mode by pressing the
Li-ion
Li-ion
8
Translation of the original
instructions
button while plugging in the mains plug until the
button for 3 seconds.
button again.
button again for 3 seconds (or wait 10 seconds without pressing the button).
Lead-acid/gel charging mode (57.2 V/8 A):
Mode for charging 48 V lead/liquid batteries from 15 Ah to 160 Ah.
7-step automatic charging cycle.
Lead Liquid/Gel-Traction charging mode (57.6 V/8 A):
Mode for charging 48 V lead/liquid batteries from 15 Ah to 160 Ah.
7-step automatic charging cycle.
Lead-acid AGM charging mode (58.8 V/8 A):
Mode for charging 48 V lead/AGM batteries from 15 Ah to 160 Ah.
7-step automatic charging cycle.
Lead AGM-traction charging mode (58.8 V/8 A):
Mode for charging 48 V lead/AGM batteries from 15 Ah to 160 Ah.
7-step automatic charging cycle.
Lithium Iron Phosphate charging mode 54.0V/15 cells (54.0 V/8 A):
Mode for charging 48 V LiFePO4 lithium batteries from 8 Ah to 160 Ah.
6-step automatic charging cycle.
Lithium Iron Phosphate charge mode 58.0V/16 cells (57.6 V/8 A):
Mode for charging 48 V LiFePO4 lithium batteries from 8 Ah to 160 Ah.
6-step automatic charging cycle.
Lithium-ion charging mode 54.0V/13 cells (54.0 V/8 A):
Mode for charging 48 V lithium-ion batteries from 8 Ah to 160 Ah.
6-step automatic charging cycle.
Lithium-ion charge mode 58.0V/14 cells (58.1 V/8 A):
Mode for charging 48 V lithium-ion batteries from 8 Ah to 160 Ah.
6-step automatic charging cycle.
GYSFLASH 8.48 PL-E
or indicator light comes on.