Publicidad
Idiomas disponibles
Idiomas disponibles
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
-
Kitchen hood
-
Assembly kit (depending on model)
-
Instruction manual
3. OPERATION
Intallation (external ventilation)
V-flap assembly
If the kitchen hood is not fitted with the V 1 flap, the half-pieces must be fitted to the body
of the kitchen hood. The pictures only show an example of how to mount the V-flap, as the
output may vary according to different models and configurations.
To mount the V-flap 1 you must:
-
Mount the two half-pieces 2 on the main body 6.
-
Pin 3 must be facing upwards.
-
The shaft 4 must be inserted into the holes 5 of the main body.
-
Repeat all operations for the 2nd part.
Fig. 2
Installation
If you have an outlet to the outside, your kitchen hood can be connected as shown in figure 3
by means of an extraction duct (enamel, aluminium, flexible tube, or non-flammable material
with an inner diameter of 150 mm).
1.
Before installation, switch off the kitchen hood and unplug it from the mains socket.
2. The kitchen hood should be placed at a distance of 65~75cm above the cooking surface
3. Drill 5 φ8 mm holes in a suitable location to accommodate the hook and inner bracket
for best effect. Fig. 4
once the installation height is set and keep it aligned. The fixed position of the inner
support is the highest place of the chimney. Fig. 5
4. Screw and tighten the hook to the wall with the 3 screws (4 x 40 mm) and plugs supplied
and use 2 screws ST4*40 mm to fix the inner bracket.
5. Install the expansion pipe in the outlet and secure it with a flange. Fig. 6
Key Fig.6
a.
Expansion tube
b.
Flange
6. Attach the outer chimney support to the external chimney, and make sure that the inner
chimney can be adjusted to the height. Fig. 7
FLUX PM 604300 INOX C / FLUX PM 604300 BLACK C
ENGLISH
57
Publicidad
