Coffee brewing
1. Lift the water tank cover and fill it with potable water.
2. Place the funnel in its bracket, make sure it is positioned correctly, and then fit the filter.
3. Add the right amount of coffee powder in the filter. You can increase or decrease the
amount of coffee powder to your liking.
4. Gently shake the funnel and filter to distribute the coffee evenly; then, close the water tank
cover and make sure it is positioned correctly.
5. Insert the glass jar into the heating plate.
6. Press the power button, the indicator light will light up, then the coffee machine will start
to operate. During the brewing process, you can press the power button at any time to
stop operation.
7. Wait until the coffee has finished dripping before removing the glass jar.
8. The keep-warm function will be activated, and the machine will switch off automatically
after 40 minutes if no further operation is performed.
Note:
-
The water level should not exceed the maximum mark or fall below the minimum mark on
the tank.
-
Do not open the water tank cover during the brewing process to avoid getting burnt by
steam or damaging the coffee machine due to the backflow of hot water.
-
The ground coffee absorbs a certain amount of water, so the amount of coffee poured into
the jar may be less than the amount of water put into the tank.
-
Do not touch the heating plate during operation, as it reaches high temperatures, and you
may get burnt.
-
If you are not going to use the coffee machine for a long time, unplug it.
-
Do not immerse the device nor the power supply in water or other liquids. The temperature
of freshly brewed coffee is very high, so be careful when pouring it to avoid getting burnt.
4. CLEANING AND MAINTENANCE
Warning: unplug the appliance before cleaning and allow the heating plate to cool down
sufficiently to avoid burns. Do not immerse the machine or power cord in water or other liquids
to avoid any danger.
-
After each use, open the tank cover and remove the filter to empty the coffee grounds;
clean the filter and the glass jar.
-
Wipe the outer surface of the product with a soft, slightly damp cloth to remove dirt.
-
When brewing coffee, water droplets may form on the top of the funnel and fall on the
hotplate. Once it has cooled down, wipe it with a cloth dampened with lukewarm water
and dry it.
COFFEE 56 DROP/ COFFEE 56 HEAT
ENGLISH
43