cecotec BOLERO AGUAZERO 4101 FULL-BI E Manual De Instrucciones página 101

Problem Possible causes
Fuse has blown
or circuit breaker
The has been tripped
dishwasher
The power
does not work
supply is not on
Water pressure
is too low
Drainage pump Overflow
does not stop
Some sounds are
normal
Utensils are
Noise
not secure in
the baskets or
something small
has fallen out of
a basket.
Engine humming
There is foam Unsuitable
inside the detergent
dishwasher
Spilled rinse aid
The interior is Detergent with
stained colouring agent
was used
Possible solution
Replace the fuse or reset the circuit breaker in the
main switchboard of your home. Remove any other
device sharing the same circuit as the dishwasher.
Make sure the dishwasher is on and door is properly
closed. Make sure that the power cord is plugged into
the socket properly.
Check that the water supply is connected properly and
that the water is turned on.
The system is designed to detect an overflow. When it
detects this, it switches off the circulation pump and
switches on the drain pump.
Sound of detergent dispenser opening.
Make sure that everything is securely fastened in the
dishwasher.
The dishwasher has not been used regularly. If you
do not use it often, remember to schedule it to fill and
empty every week, which will help keep the gasket
moist.
Use only detergent special for dishwashers to prevent
foam formation. If there is foam forming, open the
dishwasher and let it evaporate. Add 4 litres of cold
water inside. Close and lock the dishwasher, then
start the pre-rinse wash cycle to drain the water.
Repeat the process if necessary.
Always clean spilled rinse aid immediately.
Be sure to use dye-free detergents.
BOLERO AGUAZERO 4101 FULL-BI E
ENGLISH
101