cecotec BOLERO AGUAZERO 4101 FULL-BI E Manual De Instrucciones página 98

ENGLISH
8. HOW TO BUILD IN THE DISHWASHER
8.1 Before installation
The back of the dishwasher must face the wall, the water inlet and drain hoses must be
properly connected to one side or the other of the appliance.
The dimensions required to build in the dishwasher are shown in figure 23.
Fig. 23 key:
1.- Connectors for the power supply cable, water inlet hose and drain hose.
2.- Space for built-in dishwasher
Fig. 24 key:
1.- Full integration
2.- Semi-integration
8.2 Installation of the decorative front panel
The dimensions of the front panel are shown in figure 25.
Fig. 25 key:
1.- 2-ø2 holes (depth 10 mm)
2.- 4-4x42 wood screws
3.- 2-ø2 holes (depth 10 mm)
4.- 4-4x42 wood screws
To fix the panel, follow the instructions in figure 26.
Fig. 26 key:
1.- "T" shaped connector
2.- Install in the direction of the arrow, 2-4x 26 wood screws
3.- Remove 4-ST4x12 screws and replace with 4-ST 4x42 wood screws.
4.- Dishwasher door (2-5 kg)
5.- Dishwasher door
6.- Panel
8.3 Setting the spring tension on the door
After fitting the panel, try opening and closing the door to check the balance and whether the
door can remain in the same place without imbalance. If not, you can adjust it by using a CR-V 4
mm Phillips screwdriver and adjusting the sides of the door as shown in figure 27.
8.4 Installation of the skirting board (baseboard)
Figure 28
1.- Panel (decorative)
2.- Control panel
3.- Flexible panel 5~25 mm
BOLERO AGUAZERO 4101 FULL-BI E
98