cecotec BOLERO AGUAZERO 4101 FULL-BI E Manual De Instrucciones página 86

ENGLISH
Tips
When combined products are used, the rinse aid and salt indicator stop working. It may be
useful to select the lowest possible setting for water hardness.
To select the 3 in 1 function
Press the power icon and select the 3 in 1 washing cycle by pressing the ALT icon until the 3 in
1 indicator light flashes.
The 3 in 1 washing cycle will be activated after pressing the start/pause icon.
To cancel the 3 in 1 function
If you wish to switch to the use of a standard detergent system, it is recommended that:
-
Refill both the salt and rinse aid compartments.
-
Set the water hardness setting to the highest possible position and run the appliance for
-
three normal cycles without load.
Readjust the water hardness according to the conditions in your region.
-
Note: the 3 in 1 wash cycle is an additional function and must be used in conjunction with
another wash programme (Intensive, Eco or Soft).
5. LOADING THE DISHWASHER BASKETS
For best dishwasher performance, follow these loading guidelines. The characteristics and
appearance of the baskets may vary depending on the model.
Warning: before or after loading the dishwasher baskets
-
Scrape off any leftover food. It is not necessary to rinse the dishes under running water.
-
Place the dishwasher items as follows:
Items like mugs, cups, pans/pots, etc. must face downwards.
-
Curved items or with holes should be loaded at an incline to allow water to drain out. All
-
utensils must be stacked securely and must not be moved in such a way as to prevent the
spray arms from rotating during washing.
Very small items should not be washed in the dishwasher as they could easily fall out of
-
the baskets.
Removing the dishes
To prevent water from dripping from the upper basket to the lower basket, it is recommended
to unload the lower basket first and then the upper basket.
BOLERO AGUAZERO 4101 FULL-BI E
86