cecotec BOLERO AGUAZERO 4101 FULL-BI E Manual De Instrucciones página 103

There is a Hard
white film
on the inner
surface
The
detergent Detergent residue
dispenser clogs the oil seal.
lid cannot
be closed
properly
There is still
detergent The dishes block
in the the detergent
dispenser dispenser.
Steam is This phenomenon
formed is normal
There are Aluminium items
black or grey have brushed
marks on the against the
tableware tableware
There is
standing This is normal
water at
the bottom
of the
dishwasher
Dispenser
The overfilling or rinse
dishwasher aid spillage
has a leak
Dishwasher is not
level
Note:
If none of these situations match your problem, do not attempt to disassemble, or repair
the appliance by yourself. Repairs carried out by unqualified persons may result in injury or
serious malfunctions. Contact the official Cecotec Technical Support Service. The repair must
be carried out by an authorised technician, and you must use only original spare parts.
To clean the interior, use a soft and damp cloth with
detergent for dishwasher and use rubber gloves.
Never use any cleaner other than dishwasher
detergent, otherwise foaming may occur.
Clean detergent residues adhering to the inside of the
dispenser.
Load the dishes again correctly.
During drying and draining of the water, some steam
escapes from the ventilation grille next to the door
locking system.
Use a specific mild cleaner to remove these marks.
A small amount of clean water around the outlet
at the bottom of the dishwasher keeps the seal
lubricated.
Be careful not to overfill the rinse aid dispenser.
Spilled rinse aid could cause excessive foaming and
lead to overflow. Wipe any spills with a damp cloth.
Make sure that the dishwasher is level.
BOLERO AGUAZERO 4101 FULL-BI E
ENGLISH
103