cecotec BOLERO AGUAZERO 4101 FULL-BI E Manual De Instrucciones página 81

Water hardness table
Water hardness
°Clark Range
0-8 soft
9-10 soft
11-12 medium
13-15 medium
16-20 medium
21-26 hard
27-38 hard
39-62 hard
2. Adding salt into the water softener
Always use salt intended for use with dishwasher.
NOTE: if your model does not have a water softener, you can skip this section.
Descaler
Water hardness changes from place to place. If hard water is used in the dishwasher,
-
limescale deposits will form on the dishes and cutlery.
The appliance is equipped with a special water softener that uses a salt container
-
specifically designed to remove limescale and minerals from the water.
The salt container is located under the lower basket and must be filled as follows:
-
Warning!
Only use salt specifically designed for dishwasher use. Any other type of salt not
-
specifically designed for dishwasher use, especially table salt, will damage the descaler.
In case of damage caused by the use of unsuitable salt, Cecotec does not give any
guarantee and is not liable for any damage caused.
Only add salt just before starting one of the full washing programmes.
-
This will prevent any grains of salt or salty water, which may have been split, remaining
-
on the bottom of the machine for any period of time, which may cause corrosion.
After the first washing cycle, the light on the control panel will turn off.
-
mmol/l
0-1.1
1.2-1.4
1.5-1.8
1.9-2.1
2.2-2.9
3.0-3.7
3.8-5.4
5.5-8.9
BOLERO AGUAZERO 4101 FULL-BI E
Set value on the
machine
H0
H1
H2
H3
H4
H5
H6
H7
ENGLISH
Water regeneration
occurs every
"x" programme
sequence
Off
13
9
7
5
4
2
1
81