Roadstar TRA-2291 Manual De Instrucciones página 12

WARNINGS
This unit operates on 230V ~ 50Hz. If the unit is not used for a long period
of time, remove the plug from the AC mains.
This unit must not be exposed to moisture or rain.
The power switch in this unit is mounted on the secondary
circuit and does not disconnect the whole unit from the mains in OFF
position.
Ensure all connections are properly made before operating the unit.
This unit should be positioned so that it is properly ventilated. Avoid
placing it, for example, close to curtains, on the carpet or in a built-in
installation such as a bookcase.
Do not expose this unit to direct sunlight or heat radiating sources.
Make sure all batteries are inserted according to the proper
polarity. Do not mix old batteries with new ones.
If the unit is not used for a long period of time (more than 1 month),
remove all batteries from their compartment to avoid possible leaking.
1 2
TRA-2291
AC/DC Portable Radio.
LOCATION OF CONTROLS
1. VOLUME Control
2. TUNING Control
3. Carrying HANDLE
4. FM Antenna
5. HEADPHONE Jack
6. RADIO Dial Scale
7. ON/OFF / BAND Selector (MW/FM)
8. AUX-IN
9. AC cable socket
10. Battery compartment
11. Power Indicator
12. Speaker
POWER SUPPLY
Battery Operation
• Open the Battery Compartment (10) at the back of the unit.
• Insert 4 UM-3 batteries following the polarity diagram shown inside the battery
compartment.
• Batteries should be removed from the compartment if the unit is not to be used for
some time.
• Flat batteries should be removed from the unit to avoid leakage.
AC Power Operation
• Connect the AC Power Cord to your AC household mains outlet and switch on the
mains supply. Make sure the voltage is compatible.
Before switching on make sure that the voltage of your electricity supply is the same as
that indicated on the rating plate.
For your own safety read the following instructions carefully before attempting to connect
this unit to the mains.
MAINS (AC) OPERATION
This unit is designed to operate on AC 230V 50Hz current only. Connecting it to other