Descargar Imprimir esta página

Bosch HMV3063U Manual De Instalación página 8

Ocultar thumbs Ver también para HMV3063U:

Publicidad

Idiomas disponibles

Idiomas disponibles

Install Appliance
Removing the mounting plate
Note: To avoid possible damage to the work surface or
to the bottom of the appliance, cover the work surface.
Remove any remaining contents from the appliance
1.
cavity.
Remove the screws from the mounting plate.
2.
The mounting plate will be used as the rear wall
template and for mounting.
Reinstall the screws into the holes where they were
3.
removed.
Note: To avoid damage to the appliance, do not grip or
use the door or door handle while the appliance is
being handled.
Finding the wall studs
Note: The appliance must be connected to at least one
wall stud. If no wall studs exist within the cabinet
opening, do not install the appliance.
Locate the edges of the wall studs within the cabinet
1.
opening by using:
- a stud finder or
- a hammer (tapping lightly across the mounting
surface to find a solid sound).
2.
Place a mark halfway between the edges and draw a
line down the center of the studs (See possible wall
studs configuration).
Possible wall stud configurations
These depictions show examples of preferred installation
configurations with the mounting plate.
Note: Care must be taken when drilling holes. Electrical
wires may be concealed behind the wall covering and
contact with them could result in electrical shock.
8
No wall studs at corner holes
If wall stud is within 6¼" (159 mm) of the vertical
centerline, only Room Venting (recirculation) or Roof
Venting installations can be done.
Wall stud at one corner hole
Wall studs at both corner holes

Publicidad

loading

Este manual también es adecuado para:

Hmv3053u300 serieHmv3023u