Lavorwash SW 2600 BT Manual De Instrucciones página 31

ALL THE EQUIPMENT NEEDED FOR PERSONAL PROTECTION (GLOVES, MASKS, WHITE-LENS GLASSES, KEYS, TOOLS,
ALWAYS KEEP THIS MANUAL HANDY FOR QUICK REFERENCE (IN CASE OF LOSS, ASK YOUR DEALER FOR
RESERVES THE RIGHT TO MAKE CHANGES OR UPGRADE ITS MACHINES, WITHOUT ANY OBLIGATION TO UPGRADE
ALL LAVORWASH MOTOR-SWEEPERS CONFORM TO EEC STANDARDS AND ARE LABELLED:
CHAPTER 2 – PURPOSE OF THE SWEEPER
As per directive EC and its ensuing amendments, every machine is supplied with a manual for its use and maintenance.
Should this documentation result missing, the user is kindly requested to order it.
Every machine is accompanied by the following documentation:
- Handbook for use and maintenance
- Handbook for use and maintenance of engine (endothermic versions)
- Declaration of conformity to directive EC and its ensuing amendments.
With the aim of using the machine correctly and with maximum safety, the user must carefully read this entire manual, paying
particular attention to the sections regarding potential risks, safety regulations and emergency operations.
All the articles for the personal protection of the operator, specifically indicated in the manual, (gloves, masks, glasses, etc.)
must be supplied by the user.
The terms front, rear, left and right used in this publication always refer to the driving position occupied by the operator.
To assure the longest possible life of the machine parts, the instructions in this handbook must be followed closely and only
original spare parts must be used.
Data contained in this documents are liable to change since the Manufacturer reserved the right, in any given moment, to
make modifications with the aim of improving the machines.
UNPACKING:
Having eliminated the outer packaging, free the machine from the pallet as follows:
1) Release the front wheel brake
2) Remove the sticky tape Detail C blocking the handlebar
3) Open the bin Detail A and pull out the two handlebar supports Detail B Fig.1
4) Screw the handlebar supports Part. B into the holes Part. E Fig. 1
5) Screw the ends of the handle into the holes Detail D on the supports as shown in Fig.1/B
6) Take the machine off the pallet: according to the machine weight, written on the CE label, this can be
different ways:
a) With the aid of one or more people provided with gloves, lift the machine, holding it by handle at the
front, and stand it on the ground.
b) With the aid of a slanting board (not longer than 80 cm not to damage the dust flaps) placed against the
narrowest side of the bench, slide the machine down until the floor.
IMPORTANT: Check that the machine has not been damaged. In the case of apparent faults, do not attempt to
use the machine and inform the supplier or the manufacturer.
ETC.) MUST BE PROVIDED BY THE USER.
FOR EASIER READING, REFER TO THE CONTENTS PAGE.
ANOTHER COPY)
LAVORWASH S.P.A.
PREVIOUSLY- SOLD MACHINES.
Pag. 31
CHAPTER 3 - PREPARATION
done in