Auping AVS Manual De Instrucciones página 24

4.2 Manually adjustable sections
Raise back section
Pull the adjustment cord and lean
forward with the upper part of your
body. The back section will then move
up automatically. Release the cord when
you reach the position you want.
Lower back section
Pull the adjustment cord and lean
backwards. The back section will go
down. Release the cord when you reach
the position you want.
If necessary, you can adjust the power
of the gas spring yourself (see 4.3).
Foot end
The foot end has six adjustable
positions. Carefully pull on the handle
until the desired position is reached.
To put the foot end into a lower position
you must first pull it up as far as it will
go and then lower it again.
4.3 Adjusting the power of the gas
spring
The power with which the back section
of the mesh base is raised and lowered
is adjustable. There are three settings:
1. light (top hole): if you select the 'light'
setting, the back section is easiest to
push flat.
GB22
_03QVU_4459 BW.pdf - pag.22
2. normal (middle hole): standard
setting.
3. heavy (bottom hole): if you select
'heavy', the back section comes up
with extra force.
4.4 Adjusting the spring tension
1. Lift the back section half way up.
2. Unscrew the plastic notched nut
(see fig. 2).
fig. 2
3. Attention: support the back section
and remove the connecting pin (pay
attention to the plastic bearing bush
in the eyelet of the gas spring).
4. Place the eyelet of the gas spring in
the required position. The top hole
towards the mesh results in the
lightest adjustment.
5. Press the connecting pin through the
lifting arm and the eyelet of the gas
spring (pay attention to the plastic
bearing bush in the eyelet of the gas
spring).
6. Tighten the plastic notched nut (see
fig. 3).
LET OP !!! Lage resolutie!
November 17, 2009