Publicidad
Idiomas disponibles
Idiomas disponibles
Use
Installation on a wall
WARNING!
■
Before wall mounting, make sure that there is
no damage to any cables in the vicinity of the
drill holes required for the mounting.
■
Route the mains cable so that it does not
obstruct you and no one can pull on it
accidentally.
■
Do not allow children to play with the appli-
ance, even when it is mounted on the wall.
■
Never operate the charger on a combustible
surface.
■
Never place the charger on a damp surface.
■
Mounting the charger behind doors or within
their swinging range is not recommended, as
there is a risk of it being torn off or otherwise
damaged.
The charger has two holes on the back for wall
installation. You can hang it on a wall, taking the
safety instructions into account. To do this, use two
screws (not supplied) with the specified dimensions
and spacing (see fig. on the fold-out page).
Charging the battery pack
CAUTION!
►
Always unplug the appliance before you
remove a battery pack from or connect a
battery pack to the dual high-speed charger.
NOTE
►
Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is going to be stored
for an extended period, the charge level must
be checked at regular intervals. The optimum
charge level is between 50% and 80%. The
storage climate should be cool and dry, and
the ambient temperature should be between
0°C and 50°C.
♦
Slide one or two battery packs into the dual
high-speed charger
♦
Insert the power plug into the socket.
■
4
│
GB │ IE
.
♦
The charge level of the respective battery pack is
indicated by the corresponding LEDs
and the adjacent illustrations:
LED 1
flashes: The battery pack is empty
.
LED 2
flashes: The battery pack is 1/3
charged.
LED 3
flashes: The battery pack is 2/3
charged.
All LEDs
/ /
The battery pack is fully charged.
ATTENTION!
♦
If all of the LEDs
the battery pack has overheated and cannot
be charged.
♦
When charging is complete, disconnect the
dual high-speed charger
and remove the respective battery packs.
♦
You should always switch the dual high-speed
charger
off for at least 15 minutes between
successive charging processes. To do this,
disconnect the power plug from the mains
power socket.
Cleaning
CAUTION!
►
Always unplug the charger before cleaning it.
►
Do not clean the charger with water.
■
Clean the appliance with a dry or slightly
moistened cloth.
Maintenance and storage
■
If you do not intend to use the appliance for an
extended period, remove the batteries and store it
in a clean, dry place away from direct sunlight.
■
If a lithium-ion battery is going to be stored
for an extended period, the charge level must
be checked at regular intervals. The optimum
charge level is between 50% and 80%. The
optimum storage environment is cool and dry.
■
Never try to repair damaged batteries.
Batteries should only be maintained by the manu-
facturer or an approved customer service centre.
/ /
light up permanently:
/ /
flash, this means
from the mains
PDSLG 20 A1
Publicidad
