SunPower Maxeon 3 SPR-MAX3-COM Serie Instrucciones De Seguridad E Instalación página 23

SunPower Performance 6 Residen al and Commercial Solar Panel
(SPR-P6-XXX-BLK, SPR-P6-XXX-COM-XS)
50
TOP CLAMPS
Moun ng
Moun ng Configura on Diagram
Configura on
Descrip on
Front View Back View
Long Side Moun ng,
Rails Perpedincular
to Moun ng
Frame
Long Side Moun ng,
Rails Perpedincular
to Moun ng
Frame
Long Side Moun ng,
Point Supported
Long Side Moun ng,
Rails Parallel to
Moun ng Frame
Short Side Moun ng,
Point Supported
(End Mount)
Short Side Moun ng,
Rails Parallel to
Moun ng Frame
(End Mount)
1 In the cases where hybrid moun ng is necessary (combina on of long and short side moun ng), the lowest
design load values should be considered as allowable design load.
2 Test loads are for informa on purposes only, design loads should be considered for the project design.
3 Design Load considers 1.5 Factor of Safety, Test load = Design load x 1.5. Product Warranty covers only design
load values. The design loads listed in this table supersede all other loads that may be defined by other
par es, unless there is a formal authoriza on by Maxeon.
©2024 Maxeon Solar Technologies, Ltd. All rights reserved. Specifications included in this manual are subject to change without notice.
Safety and Installation Instructions - Document 001-15497 Rev.AB
287
402 502
1100 mm
1808 mm
A - Ground Holes (4X Ø 4.2mm)
B - Moun ng Holes (4X 9mm (W) x 14mm (L), R4.5mm)
Measurement Tolerances are +/-3mm for the Length and Width of the module.
Moun ng Zone
Test Load Design Load
Loca ons
(distance from corner
Downward/Upward Downward/Upward
(Pa)
in mm)
217 - 617 +2700/-2000
+1800/-1333
+1333/-1333
50 - 287 +2000/-2000
287 - 402 +2700/-2000 +1800/-1333
402 - 502 +5400/-2400 +3600/-1600
+2000/-1800 +1333/-1200
502 - 754
50 - 402
+2000/-2000 +1333/-1333
+1333/-1600
402 - 502 +2000/-2400
+933/-1200
502 - 754 502 - 754
+1400/-1800
50 - 402 +2800/-1800 +1867/-1200
+1867/-1200
402 - 502 +2800/-1800
+1867/-1200
+2800/-1800
502 - 754
0 - 221 +1600/-1400
+1067/-933
221 - 321
+1200/-800
+1800/-1200
+1400/-1400 +933/-933
0 - 221
221 - 321 +1600/-1600 +1067/-1067
MAXEON SOLAR TECHNOLOGIES, LTD.
754 502
754
GEN 4.4 FRAME PROFILE
(Pa)
SIDE FRAME PROFILE
30 mm
33 mm
4 Bo om flange moun ng
5 Range indicates posi oning of the clamp and not the rails
6 Slight bending may occur due to weight of the module.
402 50
287
B A
END FRAME PROFILE
30 mm
24 mm
EN