Hotpoint Ariston MF20SIXHA Manual Del Usuario página 12

AUTO CLEAN
T
HIS AUTOMATIC CLEANING CYCLE
clean the microwave oven cavity and
remove unpleasant odors.
Before starting the cycle:
Put 300ml water into a container (see
our recommendations in the below
section "Tips and suggestions").
Place the container directly in the
middle of the cavity.
To Start The Cycle:
Press the Auto Clean button, the
cleaning cycle duration will be visible
on the display.
Press the START button to start the
function.
When The Cycle Is Finished:
Press the Stop button.
Remove the container.
Use a soft cloth or a paper towel with
mild detergent to clean the interior
surfaces.
Tips and suggestions:
For a better cleaning result, it is recom-
mended to use a container with a dia-
meter of 17-20cm, and a height that is
lower than 6.5cm.
It is mandatory to use a container of
light plastic material that is suitable for
the microwave.
As the container will be hot after the cle-
aning cycle is completed, it is recom-
mended to use a heat resistant glove
when removing the container from the
microwave oven.
For a better cleaning effect and removal
of unpleasant odors, add some lemon
juice or vinegar to the water.
12
will help you
GB
PRE-SET COOKING PROGRAMMES
A
SELECTION OF AUTOMATIC RECIPES
algorithms to offer optimal cooking results.
Press the Pre-set cooking program-
mes button.
Press Pre-set cooking programmes
button repeatedly or press the +/- but-
ton to select the desired recipe (see
the following table).
Press the START button to confirm
the recipe and press the +/- button to
select the weight amount in below tab-
le.
Press the START button.The function
will start.
NOTE:
According to the selected recipe, after a
certain time, the display would ask you to
add or turn or stir the food.
The cooking recipe will be confirmed once
you leave the function button for 3 seconds,
press the Pre-set cooking programmes
button again to change the recipe type.
MUTE OFF
T
HIS FUNCTION ALLOWS YOU
deactivate all the sounds played by the
applance, includes button press, warnings,
alarm, even end of the function.
Press Auto Clean button for 3 seconds to
put into mute, press the same button for 3
seconds again to turn on the sound.
This function can operate at any time.
with preset
to activate/