Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 27
Fig. 28
4.
BASIC FUNCTIONS
Note: Before using the N-Com device for the first time, recharge the battery completely for at least
10 hours. To obtain best performances from the battery, it is recommended to completely recharge
the battery the first few times. Afterwards, you can recharge the battery for shorter periods. Whenever
possible, it is best to recharge the battery completely.
System ON
System OFF
4.1.
Volume adjustment
You can easily adjust the volume by tapping the "" or the "" key. You will hear a beep when the
volume reaches the maximum or minimum level.
Some volume parameters can be adjusted through the N-Com EASYSET APP for smartphone or the
N-Com EASYSET computer program (chapter 4.4).
N.B.: The volume level set during the trip is not stored when the system is turned off. Each time the
N-Com system is switched on, the audio goes back to the set default volume level.
4.2.
Auto On / Off function
If the helmet does no move for more than 60 seconds, the B902 system goes into "deep sleep" mode.
The system is completely turned on as soon as movement is detected.
If the system is in "deep sleep" mode for more than 3 days, it turns off completely. To turn it back on,
the "ON" key need to be pressed.
The "Auto On / Off" function is enabled by default on the device.
You can enable / disable the function from the Configuration Menu (Chapter 6).
Press "ON" and keep it pressed for about 2 seconds, until the LEDs turn
on and you hear the voice announcement.
Press "ON" and keep it pressed for about 6 seconds, until the LEDs turn
off and you hear the voice announcement.
•
Unhook the right and left clips from the
shell, levering upward using a flat head
screw (or a similar tool), as shown in figure
27.
•
Completely remove the B902 system from
helmet using a flat head screwdriver (or
similar tool) and re-install the cheek padding
and the edge gasket.
13
Publicidad
