Nolan N-Com R Serie Manual De Instrucciones página 58

EN
N.B.:
•
During use of the UNIVERSAL INTERCOM, the B902 system keeps the connection active to the
MAIN DEVICE only (and not to the SECOND MOBILE PHONE or to the SATELLITE NAVIGATOR).
•
The intercom system connected to N-Com B902 may not allow simultaneous connection to a
mobile phone.
•
Only one system paired up in Universal Intercom mode can be stored.
Universal Conference
16.3.
The "Universal Conference" mode can be used to connect in conference call N-Com systems of the
"900" series and one system paired up in Universal Intercom mode.
The connection procedure is outlined in the diagram provided here below:
1. System A must have been paired up beforehand to two B systems (Universal Intercom pair
up) and C.
2. System A has to initiate the first intercom connection with system B (Universal Intercom), by
pressing the relative intercom connection command.
3. At this point, system C can join the intercom conference call, establishing an intercom
connection with system A.
4. The three systems are now in intercom conference call mode and can talk to each other at
the same time.
5. In case you wish to add another system (D), the latter must be paired up beforehand to
system C. Press the relative connection command to start a 4-participant intercom
conference call.
Universal Conference
Note: The "
systems".
Universal Conference
Note: The "
with other N- Com devices (B601, B5, B1.4, etc.).
26
(chain intercom)
" mode can also be used by connecting only "900" series N-Com
" mode can also be used by connecting "900" series N-Com systems