Philips AUT4030R400 Manual Del Usuario página 18

e. Turn on the three-way ball valve and re-connect with power. If the �lter which has
been replaced is RO �lter, turn on the puri�ed water (rotate the handle of the faucet
anticlockwise) to allow water to run for 15 minutes. After that, switch off the faucet
for at least 10 seconds, and then turn on the puri�ed water again for another 15
minutes. If it is the 3in1 �lter, turn on the �ltered water and allow water to run for 10
minutes.
f. Reset the �lter lifetime according to chapter V.
VII. Precautions
1. Warning
- Always use municipal tap water as the water source. Do not use water that is
micro-biologically unsafe or of unknown quality without adequate disinfection before
or after the system.
- This system is not intended for use by persons (including children) with reduced physical
sensory or mental capabilities, or lack of experience and knowledge unless they have
been given supervision or instruction concerning the use of the appliance by a person
responsible for their safety. Children should be supervised to ensure that they do not
play with the system.
- Be sure to handle the system gently and carefully. Do not attempt to modify or repair
the system yourself, otherwise, the warranty becomes invalid.
- This device is intended for domestic use only.
- The inlet water temperature of the system should be within 5-38℃ . When the inlet
water temperature exceeds 38℃, the �lter could be damaged and become invalid. If the
inlet water temperature is lower than 5℃, it may cause freezing and the parts of the
system to rupture, resulting in water leakage.
- Do not reverse the installation order of the �lter cartridges to avoid affecting the �lter
performance of the system.
- If the system is abnormal or faulty, stop using it immediately. Close the inlet water valve,
and turn on the faucet to empty the system. Events of faults include:
15