Philips AUT4030R400 Manual Del Usuario página 19

· Leakage
· The product is cracked or damaged
· There is an abnormal sound or burnt smell
· The power plug or power cord is abnormally hot
· The machine does not work
Please contact consumer care for inspection immediately.
- If not using the system for an extended period, turn off the water supply, and turn on
the faucet to release the internal pressure to avoid damage to the system.
VIII. Troubleshooting
Problem Problem
No water comes
out from the
faucet.
The �ow rate gets
slower.
Poor outlet water
quality.
Posibles causas
Cold water valve or the three-way
ball valve is turned off.
The system is not connected
with power.
Filter is blocked.
Inlet water pressure is low.
Filter has reached the end of life.
The system hasn't been used
for some time.
The inlet water quality is poor.
Turn on the valves.
Check if the power adapter is
connected to the system and
the power socket properly.
Replace the �lter.
Wait until the inlet water pressure
gets stable, or install a pressure
boost before the system if the
inlet water pressure is constantly
lower than 0.1 MPa.
Replace the �lter.
Turn on the puri�ed water and
allow the water to run for 5
minutes.
Always use municipal tap water
as the water source. Do not use
water that is micro-biologically
unsafe or of unknown quality
without adequate disinfection
before or after the system.
16
Soluciones