Caffitaly System S22 Manual De Instrucciones página 25

• Disassemble the milk dispenser (Fig.17), wash the parts with a detergent product, paying
particular attention to the milk jug knob, dry and reassemble.
• Make sure the jug cover pin is in the correct position, otherwise turn it clockwise (Fig.18).
• Make sure the milk dispensing knob is in the dispensing position (Fig.10).
NB: Traces of the product just dispensed may remain in the machine circuit. To ensure
the full taste of the drink, it is advisable to do a rinse cycle when dispensing a product
other than coffee.
To do the rinse cycle, see the section "Rinse cycle".
Use a soft cloth and mild detergent to
clean the surface of the appliance. Do not
use jets of water to clean the appliance.
Descaling signal: when indicator light H is on steady YELLOW, it is advisable to do the
descaling cycle, as illustrated below.
The machine has an advanced program that checks how much water is used to
dispense products. This measurement allows the user to know when the machine
needs a descaling cycle.
Make sure to use Caffi taly System descaler, which is designed to respect the technical
characteristics of the machine, in full compliance with consumer safety. The descaler
must be disposed of according to the manufacturer's instructions and/or the regulations
in force in the country of use.
CAREFULLY read the directions for use provided on the descaler package. Avoid
contact with eyes, skin and machine surfaces.
Do not turn the machine off and do not raise the lever during descaling. A person
must be present during the operation.
Do not use vinegar: it could damage your machine!
• Turn the machine off by pressing the main switch I.
• Empty and rinse out the used capsule drawer and drip-tray.
• Remove and empty the water tank.
• Mix the contents of a Caffi taly System descaler bottle with about 750 cc. of water (total
1 litre) and pour into the tank.
• First remove the container and then the milk dispenser (Fig.6), and insert the descaling
connector into its seat (Fig.13).
NB: If the descaling connection is not positioned correctly in the special milk
jug seat, the descaling cycle cannot be done.
• Place a container (at least 500 ml) under the coffee dispenser and the milk container
under the descaling connection (Fig.14).
• Make sure the lever is lowered and that there are no capsules in the capsule compartment.
• Keep buttons A and B pressed and at the same time turn the machine on by pressing
the main switch I.
• Button B is lit up, whereas indicator lights G and H blink alternately YELLOW and RED.
• Press button B to start the descaling cycle.
• The machine dispenses the descaling solution at intervals (5 dispensings with a 4-minute
pause between each, for a duration of about 25 minutes). During this phase, when
the buttons must not be pressed, indicator lights G and H blink alternately YELLOW
and RED. Empty the container, if necessary.
• When the fi rst phase has been completed, button B is lit up and the water tank is empty.
• Carefully rinse out the water tank and refi ll it with fresh water (approx. 500ml).
English
Descaling
The machine's plastic parts,
including the water tank, are
NOT dishwasher safe.
25