Caffitaly System S22 Manual De Instrucciones página 26

• Press button B to start the rinse cycle.
• The machine delivers the rinsing water until the water tank is empty. During this phase,
indicator lights G and H blink alternately YELLOW and RED.
• When the rinse cycle is completed, the machine returns to the "fi rst use" state.
• Remove the descaling connector (Fig.13).
• Fit the milk dispenser fi rst and then the jug in its special place (Fig.5).
• Carefully empty and rinse out the water tank and refi ll it with fresh water.
• Press one of the buttons A-B-C. Wait for the machine to complete the water circuit fi lling
cycle. Indicator light G goes off.
PROBLEM
No coffee comes out.
Indicator light G blinks
RED.
The coffee is not hot
enough.
The lever cannot be
lowered.
Indicator light G is lit up
steady RED.
When a button is pressed
to dispense coffee, the
machine seems to start
but then stops without
dispensing coffee, or
only dispenses a small
amount.
Coffee is dispensed very
slowly, and is of poor
quality.
The milk jug will not fi t.
26
English
Troubleshooting
POSSIBLE CAUSE
- The water tank is empty.
- The water tank is full:
a) tank not inserted
correctly.
b) Grime.
c) Limescale blockage.
d) Capsule problem.
- Cold cups / espresso cups.
- Scale build-up in machine.
- The used capsule drawer
is full.
- Capsule stuck inside the
machine.
Heating up problems.
Incorrect programming of
amounts.
Button C was used with an
espresso capsule.
Wrong position of pin in jug
lid.
CURE
- Fill the tank with fresh water. Press
a button to refill the circuit. When the
buttons are lit up steady, the appli-
ance is ready to use.
a) Insert the tank correctly and fi ll the
circuit.
b) See the section "Rinse cycle" and
"Daily cleaning".
c) Do a rinse cycle. If the problem
persists, see the section "Descaling".
d) Notify the sales point of the
blend(s)/batch(es). Replace capsules.
- Prewarm the cup.
- Descale.
- Empty the used capsule drawer.
- Remove the stuck capsule.
Turn the machine off, then on again.
If the problem persists, take the
machine to an Authorised Service
Centre.
Reprogram the amount for the
button.
See the section "Programming the
amount of coffee in a cup".
Use buttons A or B.
See Fig.18 and the section "Daily
Cleaning".