Descargar Imprimir esta página

Stanley FATMAX SFMCW223 Traducido De Las Instrucciones Originales página 8

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 47
ENGLISH
These risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks can not be avoided. These include:
Injuries caused by touching any rotating/moving parts.
u
Injuries caused when changing any parts, blades or ac-
u
cessories.
Injuries caused by prolonged use of a tool. When using
u
any tool for prolonged periods ensure you take regular
breaks.
Impairment of hearing.
u
Health hazards caused by breathing dust developed when
u
using your tool (example:- working with wood, especially
oak, beech and MDF.)
Labels on tool
The following pictograms may be shown on the tool along with
:
the date code :
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Wear ear protectors. Exposure to noise can cause
hearing loss
Wear safety glasses or goggles
Wear a dust mask
Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not store in locations where the temperature may
u
exceed 40 °C.
Charge only at ambient temperatures between 10 °C and
u
40 °C.
Charge only using the charger provided with the tool.
u
When disposing of batteries, follow the instructions given
u
p
in the section "Protecting the environment".
Do not attempt to charge damaged batteries.
Chargers
Use your STANLEY FATMAX charger only to charge the
u
battery in the tool with which it was supplied. Other batter-
ies could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
u
8
(Original instructions)
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
$
Do not probe the charger.
u
+
The charger is intended for indoor use only.
Read the instruction manual before use.
#
Electrical safety
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains volt-
age corresponds to the voltage on the rating plate.
Never attempt to replace the charger unit with a
regular mains plug.
If the supply cord is damaged, it must be replaced by
u
the manufacturer or an authorised STANLEY FATMAX
Service Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Sanding belt
2. Trigger
3. Lock-on button
4. Quick release lever
5. Main handle
6. Three position handle
7. Belt tracking adjustment knob
8. Dust exhaust port
9. Variable speed dial
10. Battery pack (not included)
11. Battery pack release button
12. Locking position dial
Use
Warning! Let the tool work at its own pace.
Do not overload.
Charging the battery (Fig. A)
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that were
easily done before.
The battery may become warm while charging; this is normal
and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging
temperature: approx. 24 °C.
Note: The charger will not charge a battery if the cell
temperature is below approximately 10 °C or above 40 °C.

Publicidad

loading

Este manual también es adecuado para:

Fatmax sfmcw223b