Publicidad
Idiomas disponibles
Idiomas disponibles
3
Panel location
Always install the panel in a position where the skipper can see it
easily.
If the engine panel is installed outsite, the supplied waterproof cover
(for the key lock) must be installed. This prevents water, salt and dirt
entering the lock when the key is removed.
When the engine panel is mounted low in the cockpit, install it in
such a way that the key cannot be damaged, by feet, for example.
Take care that the engine panel is waterproof only on the operating
side. The back of the panel should be installed in a well-protected
and ventilated space. Do not install the panel where serious vibration
can occur.
4
Panel installation
Dimensions
: 267 x 156 mm (10
Installation depth
: 120 mm (4
Fitted with
: rev. counter, operating hours counter,
voltmeter, oil pressure gauge and coolant
temperature gauge
Operating
: by removable key
The panel must be placed in a flat plate.
• Make a hole of the correct size and mount the engine panel with
the 4 screws provided. Use the supplied MPA34 drilling template
or download it from www.vetus.nl. Make sure the gasket is prop-
erly positioned between the engine panel and bulkhead.
• Connect the motor panel to the motor wiring using the available
plug connectors.
12
14
10
8
16
VOLT
A system where, if there is an alarm, the engine is stopped au-
tomatically is not recommended for propulsion engines. Dan-
gerous situations may arise if, under certain circumstances,
the engine is stopped immediately.
Engine control panel MPA34CANBS
1
/
" x 6
1
/
")
2
8
3
/
" )
4
c
aution
5
LCD display
After start-up, the panel is ready for use. The tachometer's LCD dis-
plays the default data page.
• Use the arrow buttons to scroll, up or down, through the data
pages.
The following data pages are available:
RPM
Revolutions per minute
Battery
Battery voltage
Alarms
Current alarms
Engine temp
Engine temperature
Fuel rate
Fuel consumption
DTC
Problem diagnosis code
Engine HRS
Engine running hours
Oil press
Oil pressure
5.1
Menu options
• Press the MODE button once to display the menu options from
the LCD screen.
The following menu items are available:
UNITS
setting units (US or EU)
AUDIO
switching the buzzer on or off
LIGHTING
display illumination setting
CONTRAST
display contrast setting
• Use the arrow buttons to scroll, up or down, through the menu
items.
If necessary, briefly press the MODE button to go back one step.
• Press and hold the MODE button to enter the desired menu item.
• Use the arrow buttons to select, up or down, the desired unit.
• Press and hold the MODE button to save the selection. The LCD
displays SETTING SAVED! and the panel beeps.
5.2
Used symbols
On the LCD screen located below the centrally placed tachometer,
the following symbols can be displayed:
Pre-heating
Oil pressure alarm
Coolant temperature alarm
Water in fuel alarm
Charging voltage alarm
When the alarm sounds, the skipper should take action by, for
example, stopping the engine or reducing engine speed.
< 0.75 bar
> 93 °C
note
090444.01
7
Publicidad
