Husqvarna ST 424 Manual De Usuario página 15

• Do not fill the fuel tank fully. Heat causes the fuel to
expand. Keep a space at the top of the fuel tank.
Battery safety
WARNING:
cause an explosion and cause injury. If the
battery has a deformation or is damaged,
speak to an approved Husqvarna service
agent.
WARNING:
instructions that follow before you use the
product.
• Use protective glasses when you are near batteries.
• Do not wear watches, jewelry or other metal objects
near the battery.
• Keep the battery out of reach for children.
• Charge the battery in a space with good airflow.
• Keep flammable materials at a minimum clearance
of 1 m when you charge the battery.
• Discard replaced batteries. See
28 .
• Explosive gases can come from the battery. Do not
smoke near the battery. Keep the battery away from
open flames and sparks.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
To remove the product from the carton
1. Remove loose parts included with the product. Cut
the four corners of the carton and put the end panels
down flat.
2. Remove the two screws that attach the auger
housing to the pallet. Remove the steel brackets
from the skid plates if they have it.
3. Remove all package materials.
4. Remove the product from the carton and make sure
no loose parts are left in the carton.
Loose parts
(Fig. 31)
Discharge chute (1)
(Fig. 32)
ON/OFF key (s)
(Fig. 33) Carriage bolts 5/16-18 x 2 ¼" (2)
(Fig. 34) Chute retainer
876 - 019 - 05.10.2023
A damaged battery can
Read the warning
Disposal on page
Read the warning
Assembly
• The exhaust fumes from the engine contain
carbon monoxide, an odorless, poisonous and very
dangerous gas. Do not start the engine indoors or in
closed spaces.
• Before you do the maintenance on the product, stop
the engine and remove the ignition cable from the
spark plug.
• Use protective gloves when you do maintenance on
the blades. The blades are very sharp and cuts can
easily occur.
• Accessories and changes to the product that are
not approved by the manufacturer, can cause
serious injury or death. Do not change the product.
Always use accessories that are approved by the
manufacturer.
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Only do the maintenance as given in this operator's
manual. All other servicing must be done by an
approved service agent.
• Let an approved service agent do servicing on the
product regularly.
• Replace damaged, worn or broken parts.
(Fig. 35) Handle knobs (2)
(Fig. 36) Locknut 3/8 (1)
(Fig. 37) Locknut 3/18-16 (1)
(Fig. 38)
Shear pins ¼-20 x 1.81 (6)
(Fig. 39)
Locknuts ¼-20 (6)
(Fig. 40) Locknut 5/16-18 (1)
(Fig. 41) Locknut ¼-20 (1)
(Fig. 42) Nylon washer (1)
(Fig. 43)
Carriage bolt 5/16-18 x 5/8 (1)
(Fig. 44)
Roll pin (1)
15