Thermador PH Professional Serie Manual De Instalación página 8

7. Use 2 or 3 (#14 x 3") screws to attach the bracket to
the wall as shown in Figure 4. For support of longer
hoods, use three studs. Countersink the screw heads
to prevent interference with the hood. Dry Wall
8. On the wood bracket, mark the locations used to hang ))
the hood according to Figure 5. wy
23 "a a
Po
Drywall Cooktop iat | |
Centerline i |
F t a —_|____.
i 2-3/4" ¥ |
|
i
S Cooktop
S i
Screws —— i Centerline Base of Hood
(2 ea.#14 x 3") Location
i
i
i Figure 6: Cutout Dimensions
i
: Note:
A measurement Dashed line indicates cutout needed for clearance of the
' transition.
i
HOOD A ri The transition supplied with the hood connects to standard
SIZE . 10-inch round duct. Figure 7 shows the transition
30° T3ANG connected for horizontal discharge.
36" 16-1/16"
42" 19-1/16"
48" 22-1/16" 10-1/4"
54" 25-1/16" < >
Transition
Figure 5: Hanging the Hood Centerline
{anenanmnmnmnmnenanmnmnmnsnmasnasenanon
9. Drill a 1/8" tap hole through the wooden bracket and
drywall. These (# 8 x 5/8") screws do not need to go
into the studs. 7H
10. Drill a 1/16" tap hole for the 2 (#8 x 5/8") screws into <
the wood bracket leaving 1/4" of each screw exposed I 10-1/2"
for hanging the hood. :
11. Discharge Direction: Horizontal discharge requires a
wall cutout, as shown in Figure 6, to provide clearance
for the transition. The location of the cutout is
determined by the hood installation height.
Figure 7: Transition Centerline for Horizontal Discharge
Figure 8 shows the hood configured for vertical discharge.
Installations using this method require a cutout in the
ceiling to accommodate 10" duct and the 1/2" conduit
carrying power to the unit.
English 6