Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS ( CONTINUED )
Installation Meter - Threaded Connection
1.
Remove protective plugs from the meter inlet and outlet ports.
2.
Wrap threaded male connections with thread tape or use a pipe sealant
compound compatible with petroleum fuels.
3.
Install the meter using appropriately sized fittings. "INLET" and
"OUTLET" threads are labeled to assist piping connections.
4.
Install other system components on the meter and tighten snugly.
Installation Meter - Modular Connection
1.
Using a 5mm hex wrench and 10mm open-end wrench, remove inlet
and outlet fitting. They will not be used in the modular connection
(see Figure 4a).
2.
Using 5mm hex wrench, remove the outlet of modular pump and
reattach it to the outlet flange of the meter, making sure the O-ring is
fully seated (see Figure 4b).
3.
Using the hex bolts removed in step 1, attach meter inlet flange to
pump outlet flange, making sure O-ring is fully seated (see Figure 4b.
NOTE: If modular filter adapter is also used in set-up, first attach filter
adapter to pump outlet then attach the meter and filter to the filter adapter
(see Figure 4c).
4.
Install other system components on the meter and tighten snugly.
Modular Connection Types
Outlet
Fitting
Intlet
Fitting
Figure 4a
Figure 4b
EN
Outlet
Fitting
Figure 4c
Filter
Meter
Filter
Adapter
Pump
9
Publicidad
