Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
NOTE: This pump is designed for minimum maintenance. The motor bearings
are self-lubricating. Inspect the pump and components regularly for fuel leaks
and make sure the hose and power cord are in good condition. If damaged,
replace before use. Keep the pump exterior clean to help identify leaks.
IMPORTANT: Do not use this pump for water, chemicals or herbicides.
Dispensing any fluid other than those listed in the owner's manual may damage
the pump (see BEFORE YOU BEGIN: Fueling Compatibility Statement at front
of the owner's manual). Use of the pump with unauthorized fluids will void the
warranty.
NOTE: A kit containing O-rings, motor shaft seal and gears is available for
this pump. Refer to the Repair Parts List in the back of this manual to order
the replacement kit.
Inspect and Service Bypass Poppet
To clean and service the Bypass Poppet (see Figure 1):
1.
Remove the bypass plug with O-ring, spring, and poppet with O-ring.
2.
Wipe parts and poppet cavity with a clean cloth.
3.
When inspecting O-rings, look for breaks, wear, and signs of
deterioration, such as swelling.
4.
Replace O-rings as necessary.
5.
Before seating, coat O-rings with light grease.
6.
Make sure O-rings are well seated and reinstall bypass poppet
assembly.
7.
Install the plug and torque to 90 - 100 in/lbs.
Figure 1
EN
Poppet O-Ring
Poppet
Spring
Plug
Plug
O-Rings
1
2
5
Publicidad
