Publicidad
Idiomas disponibles
Idiomas disponibles
REPAIR
Inspect and Replace Motorshaft Seal
To inspect and replace shaft seal (See Figure 2):
1.
2.
3.
4.
In order to preserve the UL Listing for the motor, do not attempt to service
the motor. For products serviced outside the factory, the UL nameplate
must be defaced to indicate that the equipment may no longer meet the
requirements for UL Listing. This does not apply to products serviced
outside the factory under the UL program for Rebuilt Motors for Use in
Hazardous Locations.
EN
Remove the (4) 1/4-20 socket head screws, (2) hex nuts, handle and
gear coverplate.
Remove the pump housing. The motorshaft seal is located on the
backside of the pump housing.
Carefully remove shaft seal (noting orientation) and inspect for wear
or damage. Apply light oil before reinstallation. Replace as needed,
making sure seal is well seated in recess.
Reinstall all parts. Torque hex screws to 75 -85 in/lbs.
7
Publicidad
