Publicidad
Idiomas disponibles
Idiomas disponibles
REMOVING
BITS
(Fig. 12)
1.
Remove the battery
pack
2.
Lock the trigger switch on
the drill/driver
by placing the
direction-of-rotation
selector
in the center position.
3.
Open the chuck jaws.
4.
Rotate the chuck in the
direction
of the arrow marked
RELEASE to loosen the
chuck jaws.
Fig. 12
Bit
_
RELEASE
NOTICE:
Do not use a wrench to tighten or loosen the chuck jaws.
5.
Remove the bit.
WARNING:
Use protective
gloves when removing
the bit from the tool, or
first allow the bit to cool down. The bit may be hot after prolonged
use.
DRILLING
(Fig. 13)
1.
2.
3.
Check that the direction-
of-rotation
selector
is at
the correct
setting
(forward
or reverse).
Secure the material to be
drilled in a vise or with clamps
to keep it from turning
as the
drill bit rotates.
When drilling hard, smooth
surfaces,
use a center punch
to mark the desired
location
of the hole. This will prevent
Fig. 13
the drill bit from slipping off-center
as the hole is started.
4.
When drilling metals, use light oil on the drill bit to keep it from overheating.
The oil will prolong the life of the bit and increase the drilling action.
5.
Hold the drill/driver
firmly, and place the bit at the point to be drilled.
6.
Depress the trigger switch to start the drill/driver.
7.
Move the drill bit into the workpiece,
applying
only enough pressure to
keep the bit cutting.
Do not force the drill/driver
or apply side pressure to
elongate a hole. Let the tool do the work.
8.
If the bit jams in the workpiece
or if the drill/driver
stalls, stop the tool
immediately.
Remove the bit from the workpiece
and determine
the reason
for jamming.
17
Publicidad
