Ego Power+ SNT2120E-AP Manual página 10

EN
The throwing distance of the snow blower is determined
in part by the incline angle of the chute deflector (Fig. E8).
E8-1 Trigger
1. To increase the distance that the snow thrown,
squeeze the trigger on the chute- deflector handle, and
then raise the chute deflector. Release the trigger on
the chute-deflector handle to lock the chute deflector
in place.
2. To decrease the distance that the snow is thrown,
simply lower the deflector with the chute-deflector
handle.
CLEARING A CLOGGED CHUTE
1. Shut the motor and auger off!
2. Remove the battery pack(s) from the snow blower.
3. Wait until the auger has stopped rotating.
4. Always use a clean-out tool, such as a wooden rod or
other clearing tools that are commercially available; do
not use your hand.
POWER INDICATOR ON THE SNOW BLOWER
The power indicator will illuminate only when the snow
blower is started.
POWER
MEANING
INDICATOR
Safety button is
depressed and the
snow blower is
Flashing powered on and
green ready to work. Each
inserted battery
pack has at least
15% of its charge.
Snow blower is
working properly
Shining
and each battery
green
has at least 15% of
its charge.
Battery pack(s)
charge level is low.
The auger does not
Flashing red turn, but the LED
headlights could
be on for a short
while.
10
56-VOLT LITHIUM-ION CORDLESS SNOW BLOWER — SNT2120E-AP
E8-2 Chute deflector
ACTION
n/a
n/a
Stop the snow
blower and
charge the
battery pack(s).
Shining The snow blower is
orange overheated.
Flashing The snow blower is
orange overloaded.
Flashing red
Communication
and green
fault.
alternately
If the LED indicator
on one or both
battery packs
flashes orange or
shines red, the
battery pack(s) is
No indication
overheated.
Other faults: switch,
light, etc.
SNOW BLOWER OVERLOAD PROTECTION
To prevent overload conditions, do not try to remove too
much snow at one time. Slow down your pace or decrease
the width of the snow-clearing swath.
Your snow blower has built-in overload-sensing elements.
When the snow blower is overloaded, the motor will
decrease the speed automatically and you will hear the
noise level of the motor decrease. In case of overload,
slow down your pace or narrow the clearing width, after
which the motor speed will resume its normal setting
automatically. If this remedy does not solve the overload
situation, the sensor will shut off the motor automatically
and the power indicator will flash orange. Remove the
battery pack(s) from the snow blower. Check to see if
there is snow or ice stuck in the auger and deck and use a
clean-out tool to clear them out as necessary. Reinstall the
battery pack(s) and restart the snow blower.
Stop the snow
blower and wait
for some time to
cool the machine.
Remove the
battery pack(s).
Check and clear
any snow that has
collected beneath
or is lodged in
the auger. Slow
down your pace or
decrease the width
of the snow-clear-
ing swath when
working.
Contact EGO
service center for
repair.
Stop the snow
blower and allow
the battery pack
to cool down.
Contact EGO
service center for
repair.