Ego Power+ SNT2120E-AP Manual página 8

EN
SPECIFICATIONS
Voltage
Clearing Width
Intake Height
Throwing Distance
Wheel Size
Recommended Operat-
ing Temperature
Storage Temperature
Weight (without battery
pack)
Measured sound power
level L
WA
Sound pressure level at
operator's ear L
PA
Guaranteed sound
power level L
WA
(measured according to
2000/14/EC)
Valuation of vibration a :
h
◾
The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another;
◾
The declared vibration total value may also be used in
a preliminary assessment of exposure.
NOTICE:
The vibration emission during actual use of the
power tool can differ from the declared value in which the
tool is used; In order to protect the operator, user should
wear gloves and ear protectors in the actual conditions
of use.
RECOMMENDED ACCESSORIES
WARNING: The following parts are subject to be
worn out from normal use. Use only identical replacement
parts listed below. Use of parts that do not meet the
original equipment specifications may lead to improper
performance and compromised safety.
8
56-VOLT LITHIUM-ION CORDLESS SNOW BLOWER — SNT2120E-AP
56 V
520 mm
330 mm
Up to 14 m
178 mm
-20°C - 10°C
-20°C - 70°C
27 kg
96 dB(A)
K=1.8 dB(A)
80 dB(A)
K=4 dB(A)
98 dB(A)
Left 1.3 m/s
2
handle K=1.5 m/s 2
Right 1.3 m/s
2
handle K=1.5 m/s
2
PART NAME MODEL NUMBER
Rubber Paddle and Rubber
ARP2120
Auger Set
Scraper Bar ASS2120
DESCRIPTION
KNOW YOUR SNOW BLOWER (Fig. A1 – A3)
1. Main Handle
2. Bail Switch (Switch Lever)
3. Power Indicator
4. Lift Handle
5. Quick-Release Lever
6. Battery Compartment Cover
7. Wheel (x2)
8. Drive-Belt Cover
9. Auger Assembly
10. LED Headlights
11. Chute Deflector
12. Chute-Deflector Handle
13. Chute-Rotation Handle
14. Hex Wrench
15. Auger-Speed Dial
16. LED Headlights Switch
17. Safety Button
18. Battery-Release Button
19. Lock Knob
20. Latch
21. Ejection Mechanism
22. Electric Contact
PACKING LIST (FIG. A1)
ASSEMBLY
UNFOLDING THE SIDE RAILS
1. Your snow blower is shipped with the side rails in the
folded, locked position (Fig. B1).
2. Open the quick-release levers on both sides and gently
pivot the side rails upwards until they come to a stop
(Fig. B2 & B3).
3. Close the quick-release levers and then tighten the
lock knobs (Fig. B4).
INSTALLING THE CHUTE
1. Use the supplied hex wrench to loosen and remove the
two sets of bolts and washers in the chute base
(Fig. C1).
C1-1 Chute base