Ego Power+ SNT2120E-AP Manual página 13

TROUBLESHOOTING
CAUSE
PROBLEM
◾
Lock knobs on the side rails and/or quick-
Side rails don't stay in
release levers are not secured.
position.
◾
Battery charge is low.
◾
The auger is frozen by snow or ice.
◾
The battery pack is overheated. The
LED indicator on the battery pack(s)
flashes orange or shines red (see the
Snow blower is not
section "BATTERY HIGH-TEMPERATURE
starting.
PROTECTION" in this manual).
◾
Incorrect steps made to power on the snow
blower.
◾
Unidentified fault
◾
The motor is on but The drive belt is worn or broken.
the auger does not
turn.
◾
After passing, the The scraper bar is worn.
snow blower leaves a
layer of snow on the
ground.
◾
The rubber paddles are worn.
The snow blower
throws less snow.
◾
Auger speed may be too low.
◾
The auger fails to get The rubber augers are worn.
traction and it requires
extra effort to push the
snow blower forward.
56-VOLT LITHIUM-ION CORDLESS SNOW BLOWER — SNT2120E-AP
SOLUTION
◾
Make sure that lock knobs on the
side rails are fully tightened and the
quick-release levers are fully closed.
◾
Charge the battery.
◾
Remove the battery pack(s) first,
then use a clean-out tool to clear the
snow or ice that obstruct the auger.
Reinstall the battery packs and
restart the snow blower.
◾
Remove the overheated battery
pack(s) from the snow blower
and wait until the battery pack(s)
cools down to approximately 67°C.
Reinstall the battery pack(s) and
restart the snow blower.
◾
(1) Press the safety button until the
power indicator flashes green. (2)
With the button depressed, pull the
bail switch upward to meet the main
handle.
◾
Contact EGO service center for
repair.
◾
Contact EGO service center for
repair.
◾
Replace the scraper following the
section "REPLACING THE SCRAPER
BAR" in this manual.
◾
Replace the rubber paddles
following the section "TO REPLACE
THE RUBBER PADDLES" in this
manual.
◾
Increase the auger speed.
◾
Replace the rubber augers following
the section "TO REPLACE THE
RUBBER AUGERS" in this manual.
EN
13